NEW QUESTION 1
DRAG DROP
Drag and drop the Cisco ACI filter entry options from the left onto the correct categories on the right indicating what are required or optional parameters.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI/guide/b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_01000.html

NEW QUESTION 2
When Cisco ACI connects to an outside Layers 2 network, where does the ACI fabric flood the STP BPDU frame?

• A. within the bridge domain
• B. within the APIC
• C. within the access encap VLAN
• D. between all the spine and leaf switches

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c07-732033.html#_Toc395143571

NEW QUESTION 3
An engineer is implementing Cisco ACI at a large platform-as-a-service provider using APIC controllers, 9396PX leaf switches, and 9336PQ spine switches. The leaf switch ports are configured as IEEE 802.1p ports. Where does the traffic exit from the EPG in IEEE 802.1p mode in this configuration?

• A. from leaf ports tagged as VLAN 0
• B. from leaf ports untagged
• C. from leaf ports tagged as VLAN 4094
• D. from leaf ports tagged as VLAN 1

Answer: A

NEW QUESTION 4
Which two protocols support accessing backup files on a remote location from the APIC? (Choose two.)

• A. TFTP
• B. FTP
• C. SFTP
• D. SMB
• E. HTTPS

Answer: BC

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/troubleshooting/b_APIC_Troubleshooting/b_APIC_Troubleshooting_appendix_010011.html

NEW QUESTION 5
Refer to the exhibit.

Which two components should be configured as route reflectors in the ACI fabric? (Choose two.)

• A. Spine1
• B. apic1
• C. Spine2
• D. Leaf1
• E. Leaf2
• F. apic2

Answer: AC

NEW QUESTION 6
An engineer is implementing a Cisco ACI data center network that includes Cisco Nexus 2000 Series 10G fabric extenders. Which physical topology is supported?
A.

B.

C.

• A.

Answer: D

NEW QUESTION 7
Refer to the exhibit.

Which Adjacency Type value should be set when the client endpoint and the service node interface are in a different subnet?

• A. Routed
• B. Unicast
• C. L3Out
• D. L3

Answer: D

NEW QUESTION 8
Which action sets Layer 2 loop migration in an ACI Fabric with a Layer 2 Out configured?

• A. Enable MCP on the ACI fabric.
• B. Disable STP in the external network.
• C. Disable STP on the ACI fabric.
• D. Enable STP on the ACI fabric.

Answer: A

NEW QUESTION 9
An engineer has set the VMM resolution immediacy to pre-provision in a Cisco ACI environment. No Cisco Discovery Protocol neighborship has been formed between the hypervisors and the ACI fabric leaf nodes. How does this affect the download policies to the leaf switches?

• A. No policies are downloaded because LLDP is the only supported discovery protocol.
• B. Policies are downloaded when the hypervisor host is connected to the VMM VDS.
• C. Policies are downloaded to the ACI leaf switch regardless of Cisco Discovery Protocol neighborship.
• D. No policies are downloaded because there is no discovery protocol neighborship.

Answer: C

NEW QUESTION 10
Which attribute should be configured for each user to enable RADIUS for external authentication in Cisco ACI?

• A. cisco-security domain
• B. cisco-auth-features
• C. cisco-aci-role
• D. cisco-av-pair

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/Security_config/b_Cisco_APIC_Security_Configuration_Guide/b_Cisco_APIC_Security_Guide_chapter_01011.html

NEW QUESTION 11
A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

• A. Under System -> Faults, right-click on the fault and select Acknowledge Fault so that acknowledged faults will immediately disappear.
• B. Create a stats threshold policy with both rising and falling thresholds defined so that the critical severity threshold matches the squelched threshold.
• C. Under System -> Faults, right-click on the fault and select Ignore Fault to create a fault severity assignment policy that hides the fault.
• D. Create a new global health score policy that ignores specific faults as identified by their unique fault code.

Answer: C

NEW QUESTION 12
Which two statements regarding ACI Multi-Site are true? (Choose two.)

• A. The Multi-Site orchestrator must be directly attached to one ACI leaf.
• B. Routers in the Inter-Site network must run OSPF, DHCP relay, and MP-BGP.
• C. ACI Multi-Site is a solution that supports a dedicated APIC cluster per site.
• D. ACI Multi-Site is a solution that allows one APIC cluster to manage multiple ACI sites.
• E. The Inter-Site network routers should run OSPF to establish peering with the spines.

Answer: AE

NEW QUESTION 13
Which endpoint learning operation is completed on the egress leaf switch when traffic is received from an L3Out?

• A. The source MAC and IP address of the traffic is learned as a local endpoint.
• B. The source MAC address of the traffic is learned as a remote endpoint.
• C. No source MAC or IP address of the traffic is learned as a remote endpoint.
• D. The source IP address of the traffic is learned as a remote endpoint.

Answer: B

Explanation:
Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c11-739989.html

NEW QUESTION 14
Which description regarding the initial APIC cluster discovery process is true?

• A. The APIC uses an internal IP address from a pool to communicate with the nodes.
• B. Every switch is assigned a unique AV by the APIC.
• C. The APIC discovers the IP address of the other APIC controllers by using Cisco Discovery Protocol.
• D. The ACI fabric is discovered starting with the spine switches.

Answer: C

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/aci-fundamentals/b_ACI-Fundamentals/b_ACI-Fundamentals_chapter_010011.html

NEW QUESTION 15
In the context of ACI Multi-Site, when is the information of an endpoint (MAC/IP) that belongs to site 1 advertised to site 2 using the EVPN control plane?

• A. Endpoint information is not exchanged across sites unless COOP protocol is used.
• B. Endpoint information is not exchanged across sites unless a policy is configured to allow communication across sites.
• C. Endpoint information is exchanged across sites as soon as the endpoint is discovered in one site.
• D. Endpoint information is exchanged across sites when the endpoints are discovered in both sites.

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c11-739609.html#CiscoACIMultiSiteoverlaydataplane

NEW QUESTION 16
Which new construct must a user create when configuring in-band management?

• A. VLAN pool
• B. management contract
• C. management tenant
• D. bridge domain

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/kb/b_KB_Configuring_Static_Management_Access.html

NEW QUESTION 17
An engineer is extending an EPG out of the ACI fabric using static path binding. Which statement about the endpoints is true?

• A. Endpoints must connect directly to the ACI leaf port.
• B. External endpoints are in a different bridge domain than the endpoints in the fabric.
• C. Endpoint learning encompasses the MAC address only.
• D. External endpoints are in the same EPG as the directly attached endpoints.

Answer: C

NEW QUESTION 18
Which tenant is used when configuring in-band management IP addresses for Cisco APICs, leaf nodes, and spine nodes?

• A. default
• B. infra
• C. common
• D. mgmt

Answer: D

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/kb/b_KB_Configuring_Static_Management_Access.html#concept_CFF63FEBE947424291B0F10E6F23DA7D

NEW QUESTION 19
When configuring Cisco ACI VMM domain integration with VMware vCenter, which object is created in vCenter?

• A. datacenter
• B. VMware vSphere Standard vSwitch
• C. VMware vSphere Distributed Switch
• D. cluster

Answer: C

NEW QUESTION 20
When creating a subnet within a bridge domain, which configuration option is used to specify the network visibility of the subnet?

• A. limit IP learning to subnet
• B. scope
• C. gateway IP
• D. subnet control

Answer: C

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/Operating_ACI/guide/b_Cisco_Operating_ACI/b_Cisco_Operating_ACI_chapter_0111.html

NEW QUESTION 21
Which protocol does ACI use to securely sane the configuration in a remote location?

• A. SCP
• B. HTTPS
• C. TFTP
• D. FTP

Answer: A

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/kb/b_KB_Using_Import_Export_to_Recover_Config_States.html

NEW QUESTION 22
......