NEW QUESTION 1
When designing the identity and access control portions for the enterprise campus network, which of these solutions would be the most appropriate solution to consider?

• A. 802.1X
• B. ACLs in the core layer
• C. Cisco Security MARS
• D. NetFlow

Answer: A

Explanation:

NEW QUESTION 2
Which design is the recommended geometric design for routed topologies?

• A. linear
• B. triangular
• C. rectangular
• D. circular

Answer: B

NEW QUESTION 3
Refer to the exhibit.

Which action can be taken in this network design to make it more resilient?

• A. Add carrier redundancy
• B. Add additional Layer 2 trunks between core/distribution switches
• C. Add additional Layer 2 trunks between access switches
• D. Extend Layer 3 connectivity to access layer using dynamic routing protocol

Answer: A

NEW QUESTION 4
Which two mechanisms are used by distance vector protocols to prevent routing loops? (Choose two.)

• A. split horizon
• B. route summarization
• C. route poisoning
• D. tuned timers

Answer: AC

NEW QUESTION 5
Which technology should a company use to connect a branch office to headquarters via an Internet connection while maintaining confidentiality and the flexibility to run a routing protocol between the two locations?

• A. GRE over IPsec
• B. IPsec
• C. GRE
• D. SSL VPN

Answer: A

NEW QUESTION 6
Which option is an example of a fixed two-level hierarchical routing protocol?

• A. OSPF
• B. RIPv2
• C. EIGRP
• D. static routes

Answer: A

NEW QUESTION 7
Which Cisco technology can connect more than two switches so that they behave as on switch?

• A. Ether Channel
• B. Stack Wise
• C. VSS
• D. routing

Answer: B

NEW QUESTION 8
Which two considerations are important when designing the access layer? (Choose two)

• A. routing between VLANs
• B. HSRP implementation
• C. load balancing
• D. QoS services
• E. port security

Answer: DE

NEW QUESTION 9
Which VPN tunneling technology supports IP multicast?

• A. IPsec direct encapsulation spoke-to-spoke
• B. IPsec direct encapsulation hub-to-spoke
• C. IPsec VTI
• D. Cisco Easy VPN

Answer: C

NEW QUESTION 10
What two factors should be considered when deploying an enterprise campus network? (Choose two.)

• A. employees
• B. geography
• C. applications
• D. administration
• E. throughput

Answer: BC

NEW QUESTION 11
Which scenario is the best example of a single-homed connected infrastructure?

• A. a data center that is connected to one service provider over an MPLS circuit and another service provicer over an Ethernet connection.
• B. a remote office that is connected to the WAN using a DSL provider and a cable provider.
• C. a small office that uses a DSL link to connect to the WAN.
• D. to corporate office that uses two separate routers to connect to two different service providers.

Answer: C

NEW QUESTION 12
A network engineer must collect application-level information of deep attack?

• A. NBAR
• B. CiscoWorks
• C. SNMP collector
• D. NetFlow collector
• E. Syslog

Answer: A

NEW QUESTION 13
Which tool captures network traffic, decodes the protocols in the captured packets, and provides statistics to characterize errors, and response time?

• A. continuity tester
• B. protocol analyzer
• C. spectrum analyzer
• D. bit error rate tester

Answer: B

Explanation: Protocol analyzeris a tool that captures network traffic,decodes the protocols in the captured packets, andprovides statistics to characterize load, errors, andresponse time

NEW QUESTION 14
Multicast has been enabled and configured in the Enterprise, and PIM Sparse-mode has been enabled on all VLANs. What feature is required to stop multicast traffic from being broadcasted on the access layer switches?

• A. IGMP snooping
• B. Multicast boundary filter
• C. PIM dense-mode
• D. Dynamic ARP inspection

Answer: A

NEW QUESTION 15
An organization is deciding what routing protocol to use throughout their network. What must be considered if routing is to be performed at the access layer?

• A. reduced scalability of the network when introducing a large number of switch blocks into the routing table
• B. centralized management of access control lists at the distribution layer
• C. reliability when implementing routing over spanning-tree at the access layer
• D. performance differences between core, distribution and access layer equipment

Answer: D

NEW QUESTION 16
Drag the STP toolkit term on the left to the definition on the right.

Answer:

Explanation:

NEW QUESTION 17
Which statement about using STP in a redundant – link scenario is true?

• A. It provides the most efficient use to redundant links.
• B. it uses only one redundant link at any one time.
• C. it bonds the two links and treats them as one link.
• D. it balances traffic by transmitting packets on alternating links.

Answer: D

NEW QUESTION 18
High availability is required for a critical remote office of an enterprise. The office has already deployed two redundant WAN connections. Which action can be done to the edge router to improve the availability of the remote office?

• A. Replace the fiber uplinks with copper
• B. Use module line cards
• C. Add dual power suppliers
• D. Upgrade the uplinks from 100MB to 1G.

Answer: B

NEW QUESTION 19
What describes the link performance?

• A. Bandwidth
• B. Utilization
• C. Availability

Answer: A

Explanation: https://en.wikipedia.org/wiki/Network_performance