NEW QUESTION 1
Refer to the exhibit.

Which functionality must be enabled on router A to connect two networks for translating private addresses into "legal" public addresses on a one-for-one basis?

• A. NAT
• B. VLAN
• C. GARP
• D. PPP

Answer: B

NEW QUESTION 2
A network engineer must connect two sites. Each site has a different autonomous system number. Which method do you use to exchange routing information between the sites?

• A. OSPFv3
• B. BGP
• C. static routing
• D. EIGRP
• E. IGP

Answer: B

NEW QUESTION 3
Which command is correct for creating a virtual interface on a Cisco wireless controller?

• A. config create interface
• B. tag interface
• C. config interface address
• D. untag interface

Answer: C

NEW QUESTION 4
You design a network with the following network addresses:
192.168.168.0
192.168.169.0
192.168.170.0
192.168.171.0
192.168.172.0
192.168.173.0
192.168.174.0
192.168.175.0
Which route address is the best summary of these network addresses?

• A. 192.168.0.0/24
• B. 192.168.171.128/3
• C. 192.168.168.0/21
• D. 192.168.175.0/3
• E. 192.168.0.0/16

Answer: C

NEW QUESTION 5
What are two industry drivers that promote network virtualization? (Choose two.)

• A. device reduction
• B. application stability
• C. traffic isolation
• D. multi-vendor support
• E. reduced complexity

Answer: AE

NEW QUESTION 6
Refer to the exhibit.

Where should routes in the routing table be aggregated or summarized?

• A. in the core toward the data center
• B. in the distribution toward the access
• C. in the core toward the distribution
• D. in the distribution toward the core

Answer: D

NEW QUESTION 7
Which three Cisco technologies can you use to detect and mitigate threats? (Choose three.)

• A. NetFlow
• B. FWSM
• C. ISE
• D. VRRP
• E. sFLOW

Answer: ABC

NEW QUESTION 8
An engineer is designing a Cisco Unified Communications deployment for a customer with small sites across the country. Which deployment model keeps the call control at the data center of the primary site?

• A. campus deployments
• B. distributed deployment
• C. multisite deployment model with centralized call processing
• D. cloud hybrid service deployment

Answer: C

NEW QUESTION 9
Which subnet is the best choice for a point-to-point link?

• A. 10.120.10.0/29
• B. 10.120.10.0/28
• C. 10.120.10.1/32
• D. 10.120.10.0/30

Answer: D

NEW QUESTION 10
What is the best point to deploy the IPS, not to have false positives, since the traffic is already filtered?

• A. Inline before the firewall
• B. Inline after the firewall
• C. Passive of the firewall
• D. Passive of the Switch

Answer: B

Explanation: https://supportforums.cisco.com/t5/intrusion-prevention-systems-ids/correct-placement-of-ids-ips-in-network-ar

NEW QUESTION 11
Application servers require load balancing and security services. Where in the data center network should these services be provisioned?

• A. core
• B. aggregation
• C. Layer 3 access
• D. distribution

Answer: B

NEW QUESTION 12
Which two design decisions can improve network resiliency? (Choose two)

• A. implement redundant topology
• B. implement redundant links
• C. implement serial device connections
• D. increase data plane bandwidth
• E. reduce network size

Answer: AB

NEW QUESTION 13
Which two of these are scalability benefits of designing a network that utilizes VPNs? (Choose two.)

• A. extends the network to remote users
• B. allows networks to be set up and restructured quickly
• C. reduces dial infrastructure expenditures
• D. reduces the number of physical connections
• E. simplifies the underlying structure of a customer WAN

Answer: DE

NEW QUESTION 14
What is the recommended spanning tree protocol to use for all Layer 2 deployments in a branch office environment?

• A. CST
• B. RSPT
• C. PVST
• D. MISTP
• E. Rapid PVST +

Answer: E

NEW QUESTION 15
Which Layer in the Cisco Enterprise Archetecture model is highly available, has fast convergence, and should avoid packet manipulation?

• A. Campus distribution
• B. enterprise data center
• C. enterprise edge
• D. campus access
• E. campus core
• F. remote access VPN

Answer: E

Explanation: http://www.ciscopress.com/articles/article.asp?p=1315434

NEW QUESTION 16
If two routing protocols have the same route and prefix, which effect do they have on the routing table?

• A. Only the route with the lowest administrative distance is added.
• B. Only the route with the highest administrative distance is added.
• C. Both routes are added.
• D. Neither route is added, and a loop is formed.

Answer: A

NEW QUESTION 17
Which one of the following represent correct IPv6 Global Unicast address format?

• A. 48bit(Global Prefix)+16bit(Subnet ID)+64bit(Interface ID)
• B. 16bit(Subnet ID)+ 48bit(Global Prefix)+64bit(Interface ID)
• C. 64bit(Interface ID)+16bit(Subnet ID)+ 48bit(Global Prefix)
• D. 64bit(Interface ID)+ 48bit(Global Prefix)+16bit(Subnet ID)

Answer: A

NEW QUESTION 18
Which option is a benefit of Cisco Discovery Protocol?

• A. provides information about directly connected Cisco devices
• B. provides greater detail about collected data, including time stamping
• C. part of the IEEE 802 1ab standard
• D. combines with the network layer data that is gathered by NetFlow when using a NetFlow collector

Answer: A

Explanation: Cisco Discovery Protocol (formerly known as CDP) is a Layer 2, media-independent, and
network-independent protocol that runs on Cisco devices and enables networking applications to learn about directly connected devices nearby. This protocol facilitates the management of Cisco devices by discovering these devices, determining how they are configured, and allowing systems using different network-layer protocols to learn about each other.

NEW QUESTION 19
Which network element must be summarized in a multiarea OSPF deployment?

• A. IP address
• B. number of routes
• C. communities
• D. link state advertisements

Answer: A