It is impossible to pass Cisco 200-355 exam without any help in the short term. Come to us soon and find the most advanced, correct and guaranteed ccna wireless 200 355 official cert guide. You will get a surprising result by our ccna wireless 200 355 pdf download.
Online Cisco 200-355 free dumps demo Below:
NEW QUESTION 1
When using Cisco WCS version 7.0, which two features are available for the client troubleshooting tool when a Cisco Compatible Extensions v5 wireless client gets connected? (Choose two.)
- A. Request CleanAir reports from the client
- B. Send text messages to the client
- C. Aggregated Cisco ACS authentication client information
- D. Request the client to ping the DHCP-supplied IP gateway
- E. Display a summary of client event history
Answer: BD
NEW QUESTION 2
Answer:
Explanation: 
NEW QUESTION 3
What is a function of the service port on a WLC?
- A. controls mobility manager communications on all physical ports
- B. controls out-of-band management for system recovery and maintenance
- C. controls communication with Cisco Aps
- D. controls communications for all physical ports
Answer: B
NEW QUESTION 4
What are two modules of the CCX Lite program? (Choose two.)
- A. foundation
- B. voice
- C. RF power
- D. roaming
Answer: AB
NEW QUESTION 5
An engineer is troubleshooting why wireless clients have not been able to connect to the network. Where would an engineer verify the total number of excluded clients in the last day?
- A. Security > Miscellaneous
- B. Security > Rogues
- C. Alarms
- D. Events
- E. Clients > Troubleshoot
- F. Access Points
Answer: A
NEW QUESTION 6
What is the EIRP value for a transmitter that has a transmitter capable of 15 dBm, an antenna that has a gain of 12 dBi, and a cable that connects the transmitter to the antenna that has 1 db loss?
- A. 26 dBm
- B. 100 mW
- C. .86 dBm
- D. 165 dBm
- E. 1000 mW
Answer: A
NEW QUESTION 7
How many dbm is 40mW?
- A. 10dbm
- B. 22dbm
- C. 20dbm
- D. 16dbm
Answer: D
NEW QUESTION 8
Refer to the exhibit.
Which command was given in the wireless controller to display the active clients that are associated with an access point?
- A. show client active all
- B. show client summary
- C. show 802.11 association
- D. show ap clients
Answer: C
NEW QUESTION 9
When adding a controller to manage through Cisco WCS, which address type is used and which SNMP function does the Cisco WCS perform?
- A. The controller is managed through its MAC address and the Cisco WCS acts as a SNMP TRAP authenticator.
- B. The IP address of the controller is used and the Cisco WCS acts as a SNMP TRAP receiver.
- C. The controller is managed through its MAC address and the Cisco WCS acts as a SNMP agent.
- D. The controller connects through its MAC address to the Cisco WCS and the Cisco WCS uses the SNMP to manage the controller for all configured SNMP parameters.
Answer: B
NEW QUESTION 10
An engineer has been asked to disable all OFDM rates in the wireless environment. What three rates should be disabled to fulfill this requirement? (Choose three.)
- A. 2
- B. 5.5
- C. 6
- D. 9
- E. 11
- F. 12
- G. 18
Answer: ABE
NEW QUESTION 11
Answer:
Explanation: 
NEW QUESTION 12
Which option describes why most wireless phones and tablets do not use 802.11a/n and 40 MHz channels?
- A. a lack of radio range when using these radios
- B. a lack of device battery capacity to operate concurrent a/b/g/n radios
- C. a lack of cooling in the device necessary to operate these radios
- D. These radios would require the devices to be larger.
Answer: B
NEW QUESTION 13
After the initial deployment at a customer site, the master controller mode function was left enabled on the secondary controller after access points were primed and statically configured with primary, secondary, and tertiary controller failover. The guest anchor controller was also deployed in the architecture. The access points reboot after a power failure. Which controller will the access points associate to when the reboot process is completed?
- A. primary controller
- B. secondary controller
- C. tertiary controller
- D. guest anchor controller
Answer: B
NEW QUESTION 14
Which statement about an infrastructure basic service set is true according to IEEE 802.11 specifications?
- A. The set also is called an ad hoc network.
- B. The BSSID is generated from the first wireless client that starts up in the IBSS.
- C. The set enables the use of ESS.
- D. No signals are relayed from one client to another client.
Answer: C
NEW QUESTION 15
When configuring a WLC to support multiple WLANs, which type of interface must be created?
- A. dynamic
- B. ap-manager
- C. virtual
- D. management
Answer: A
NEW QUESTION 16
Refer to the exhibit. A customer is using central web authentication with a Cisco 5508 Wireless Controller and Cisco Identity Services Engine. An error occurs when wireless clients are redirected to the hosted splash page. What is causing the client error?
- A. Secure Web Mode is disabled on the WLC.
- B. OCSP is disabled on the WLC.
- C. Management Via Dynamic Interface is disabled on the WLC.
- D. Ethernet Multicast Forwarding is enabled on the WLC.
Answer: A
NEW QUESTION 17
The network administrator has used VLANs to separate VoIP frames from data frames in the wired network. What must the administrator use to separate those frames in the wireless network?
- A. multiple SSIDs
- B. multiple authentications
- C. multiple WEP or WPA keys
- D. multiple channels
- E. multiple 802.11 radios (a, b, g, n)
Answer: A
100% Valid and Newest Version 200-355 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/200-355-dumps.html (New 490 Q&As)