NEW QUESTION 1
Refer to the exhibit.
A user notifies the BIG-IP Administrator that http://remote company.com is NOT accessible. Remote access to company resources must be encrypted.
What should the BIG-IP Administrator do to fix the issue?

• A. Change the Listening Port on remote.company.com_vs to Port 80
• B. Add a Pool to the Virtual Server remote.company.com_VS
• C. Add an iRule to remote.company.com_vs to redirect Traffic to HTTPS
• D. Change the Type of the Virtual Server remote.company.com_vs to Forwarding

Answer: C

Explanation:
Requiring all traffic to be HTTPS access requires HTTP requests to be redirected directly to HTTPS.

NEW QUESTION 2
A BIG-IP Administrator needs to check the memory utilization on a BIG-IP system. Which two methods can the UIG IP Administrator use? (Choose two.)

• A. Run the tmsh show/sys memory command
• B. Run the tmsh show/sys traffic command
• C. Go to Statistics > Module Statistics > Traffic Summary in the configuration utility
• D. Go to Statistics > Module Statistics > Memory in the configuration utility
• E. Go to System > Disk Management in the configuration utility

Answer: AD

NEW QUESTION 3
A new BIG-IP VE is deployed with default settings. The BIG-IP Administrator completes the setup utility in the Configuration Utility. The internal self IP address fails to respond to a ping request. What is a possible cause of this issue?

• A. Port lockdown on internal self IP is set to Allow None
• B. Route is NOT assigned to internal self IP.
• C. Internal interface VLAN is set to untagged
• D. Internal interface VLAN is set to tagged

Answer: D

NEW QUESTION 4
A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

• A. Assign two Interfaces to the VLAN
• B. Set the media speed of Interface 1.1 manually
• C. Create a trunk object with two Interfaces
• D. Increase the MTU on the VLAN using Interface 1.1

Answer: C

NEW QUESTION 5
A VLAN has the following objects configured:
Self-IP 10.10.10.100 with port lockdown set to Allow default Virtual server 10.10.10.100:443 with UDP profile enabled Virtual server 10.10.10.0/24 port forwarding virtual server
Global destination NAT forwarding 10.10.10.100 to internal server 172.168.10.100
Which object will process this request when https://10.10.10.100 is entered into a browser?

• A. self-IP 10.10.10.100 with port lockdown set to Allow default
• B. virtual server 10.10.100/24 port o forwarding virtual server
• C. global destination NAT forwarding 10.10.10.100 to internal server 172.168.10.100
• D. virtual server 10.10.10.100.443 with UDP profile enabled

Answer: A

NEW QUESTION 6
A virtual server is listening at 10.10.1.100:any and has the following iRule associated with it: when CLIENT_ACCEPTED { if {[TCP::local_port] equals 21 } { pool
ftppool } elseif {[TCP::local_port] equals 23 } { pool telnetpool }
If a user connects to 10.10.1.100 and port 22, which pool will receive the request?

• A. ftppool
• B. telnetpool
• C. Non
• D. The request will be dropped.
• E. Unknow
• F. The pool cannot be determined from the information provided.

Answer: D

NEW QUESTION 7
Refer of the exhibit.

The 816-IP Administrator runs the command shown and observes a device trust issue between BIG-IP devices in a device group. The issue prevents config sync on device bigip3.local.
What is preventing the config sync?

• A. Next Active Load factor is 0 on bigip1.local
• B. Both devices are standby
• C. Next Active Load factor is 1 on bigip1.local
• D. Time Delta to local system is 12

Answer: A

Explanation:
Option A should be bioip3.local?. if choose bigip3.local, you should choose A.

NEW QUESTION 8
When using the setup utility to configure a redundant pair, you are asked to provide a "Failover Peer IP". Which address is this?

• A. an address of the other system in its management network
• B. an address of the other system in a redundant pair configuration
• C. an address on the current system used to listen for failover messages from the partner BIG-IP
• D. an address on the current system used to initiate mirroring and network failover heartbeat messages

Answer: B

NEW QUESTION 9
When initially configuring the BIG-IP system using the config utility, which two parameters can be set? (Choose two.)

• A. the netmask of the SCCP
• B. the IP address of the SCCP
• C. the port lockdown settings for the SCCP
• D. the netmask of the host via the management port
• E. the IP address of the host via the management port
• F. the port lockdown settings for the host via the management port

Answer: DE

NEW QUESTION 10
Refer to the exhibit.

According to the shown Configuration Utility stings What is the setting of the User Directory configuration under the Authentication submenu?

• A. Local
• B. Managed
• C. Remote-TACACS+
• D. Default system configuration

Answer: C

NEW QUESTION 11
To increase available bandwidth of an existing Trunk, the BIG-IP Administrator is adding additional interfaces.
Which command should the BIG-IP Administrator run from within bosh shell?

• A. tmsh create /net trunk trunk_A interfaces add {1.3.1.4}
• B. tmsh create/sys trunk trunk_A interfaces add {1.3.1.4}
• C. tmsh modify/sys trunk trunk^A interfaces add {1.3.1.4}
• D. tmsh modify /net trunk trunk_A interfaces add {1.3.1.4}

Answer: D

NEW QUESTION 12
A site is load balancing to a pool of web servers. Which statement is true concerning BIG IP's ability to verify whether the web servers are functioning properly or not?

• A. Web server monitors can test the content of any page on the server.
• B. Web server monitors always verify the contents of the index.html page.
• C. Web server monitors can test whether the server's address is reachable, but cannot test a page's content.
• D. Web server monitors can test the content of static web pages, but cannot test pages that would require the web server to dynamically build content.

Answer: A

NEW QUESTION 13
The current status of a given pool member is unknown. Which condition could explain that state?

• A. The member has no monitor assigned to it.
• B. The member has a monitor assigned to it and the most recent monitor was successful.
• C. The member has a monitor assigned to it and the monitor did not succeed during the most recent timeout period.
• D. The member's node has a monitor assigned to it and the monitor did not succeed during the most recent timeout period.

Answer: A

NEW QUESTION 14
A BIG-IP Administrator is checking the BIG-IP device for known vulnerabilities. What should the 8IG-IP Administrator upload to BIG-IP iHealth for further analysis?

• A. QKView
• B. EUD
• C. UCS
• D. tcpdump

Answer: A

NEW QUESTION 15
A site would like to ensure that a given web server's default page is being served correctly prior to sending it client traffic. They assigned the default HTTP monitor to the pool. What would the member status be if it sent
an unexpected response to the GET request.?

• A. The pool member would be marked offline (red).
• B. The pool member would be marked online (green).
• C. The pool member would be marked unknown (blue).
• D. The pool member would alternate between red and green.

Answer: B

NEW QUESTION 16
When configuring a Virtual Server to use an iRule with an HTTP_REQUEST event, which lists required steps in a proper order to create all necessary objects?

• A. create profiles, create the iRule, create required pools, create the Virtual Server
• B. create the Virtual Server, create required pools, create the iRule, edit the Virtual Server
• C. create a custom HTTP profile, create required pools, create the Virtual Server, create the iRule
• D. create required pools, create a custom HTTP profile, create the iRule, create the Virtual Server

Answer: B

NEW QUESTION 17
......