NEW QUESTION 1
How should a BIG-IP Administrator control the amount of traffic that a newly enabled pool member receives.

• A. set the Slow Ramp Time
• B. set a Connection Limit
• C. set the Priority Group Activation
• D. set a Health Monitor

Answer: A

Explanation:
Slow Ramp Time
Specifies the duration during which the system sends less traffic to a newly-enabled pool member. The amount of traffic is based on the ratio of how long the pool member has been available compared to the slow ramp time, in seconds. Once the pool member has been online for a time greater than the slow ramp time, the pool member receives a full proportion of the incoming traffic. Slow ramp time is particularly useful for the least connections load balancing mode.
Setting this to a nonzero value can cause unexpected Priority Group behavior, such as load balancing to a low-priority member even with enough high-priority servers.

NEW QUESTION 2
Which two can be a part of a pool's definition? (Choose two.)

• A. rule(s)
• B. profile(s)
• C. monitor(s)
• D. persistence type
• E. loadbalancing mode

Answer: CE

NEW QUESTION 3
A BIG-IP Administrator wants to add the ASM Module to an HA pair of BIG-IP devices. The BIG-IP Administrator has already installed a new Add-On License on both devices in the HA pair. What should the BIG-IP Administrator do next to use the module?

• A. Provision the new module on both BIG-IP device's
• B. Synchronize both BIG-IP devices
• C. Reboot both BIG-IP devices
• D. Reactivate the Licenses on both BIG IP devices

Answer: A

NEW QUESTION 4
Which two methods can be used to determine which BIG-IP is currently active? (Choose two.)

• A. The bigtop command displays the status.
• B. Only the active system's configuration screens are active.
• C. The status (Active/Standby) is embedded in the command prompt.
• D. The ifconfig a command displays the floating addresses on the active system.

Answer: AC

NEW QUESTION 5
A BIG-IP Administrator is creating a new Trunk on the BIG-IP device. What objects should be added to the new Trunk being created?

• A. Interfaces
• B. Network routes
• C. VLANS
• D. IP addresses

Answer: A

Explanation:
trunk is a portchannel, you need to add a physical interface.

NEW QUESTION 6
A BIG-IP device has only LTM and ASM modules provisioned. Both have nominal provisioning level. The BI6-IP Administrator wants to dedicate more resources to the LTM module. The ASM module must remain enabled. Which tmsh command should the BIG-IP Administrator execute to obtain the desired result?

• A. modify/sys provision asm level minimum
• B. modify /sys provision Itm level dedicated
• C. modify /sys provision asm level none
• D. modify /sys provision Itm level minimum

Answer: A

NEW QUESTION 7
A BIG-IP Administrator receives an RMA replacement for a failed F5 device. The BIG-IP Administrator tries to restore a UCS taken from the previous device, but the restore fails. The following error appears inthe/var/log/itm.
mcpd [****J: •*****»;0; License is not operational (expired or digital signature does not match contents.)
What should the BIG-IP Administrator do to avoid this error?

• A. Use the appropriate tmsh command with the no-license option
• B. Revoke the license prior to restoring
• C. Reactivate the license on the new device using the manual activation method
• D. Remove the license information from the UCS archive

Answer: A

NEW QUESTION 8
Which method is recommended for creating a new user from the CLI?

• A. Run f5adduser username' then 'f5passwd username' from bash or tmsh
• B. Run tmsh create auth user username prompt for password' from bash
• C. edit bigip.conf to add the new user and the user's clear-text password
• D. Run useradd username' then 'passwd username' from bash tmsh

Answer: B

NEW QUESTION 9
Which Virtual Server type prevents the use of a default pool?

• A. Performance (Layer 4)
• B. Forwarding (IP)
• C. Performance HTTP
• D. Standard

Answer: B

Explanation:
Forwarding (IP) cannot be associated with the pool.

NEW QUESTION 10
A virtual server is listening at 10.10.1.100:80 and has the following iRule associated with it:
when HTTP_REQUEST { if { [HTTP::header UserAgent] contains "MSIE" }
{ pool MSIE_pool }
else { pool Mozilla_pool }
If a user connects to http://10.10.1.100/foo.html and their browser does not specify a UserAgent, which pool will receive the request?

• A. MSIE_pool
• B. Mozilla_pool
• C. Non
• D. The request will be dropped.
• E. Unknow
• F. The pool cannot be determined from the information provided.

Answer: B

NEW QUESTION 11
A BIG-IP system has the following configuration:
* SNAT is set to Auto Map
* There are two VLANs internal and external
* Default route is pointed to the gateway on external VLAN
* Self P for internal VLAN is 1921.1.2
* Self IP for external VLAN is 192.1.2.2
* Floating IP addresses for internal VLAN is 192.1.1.1
* Floating IP addresses for external VLAN is 192.1.2.1
* The Virtual Server IP address is 192.1.1.100
Which IP address does the BIG-IP system use first when traffic reaches the servers on the internal VLAN?

• A. 192.1.1.100
• B. 192.1.2.2
• C. 192.1.1.1
• D. 192.1.2.1

Answer: C

NEW QUESTION 12
Interface 1.2 on a BIG-IP VE has a status of UNINITIALIZED. What is the reason for this status?

• A. Interface 1.2 has been added to a trunk.
• B. Interface 1.2 has NOT been assigned to a VLAN.
• C. Interface 1.2 has been disabled.
• D. No default route has been created.

Answer: B

Explanation:
trunk is a portchannel, you need to add a physical interface.

NEW QUESTION 13
Which statement is true about the synchronization process, as performed by the Configuration Utility or by typing b config sync all?

• A. The process should always be run from the standby system.
• B. The process should always be run from the system with the latest configuration.
• C. The two /config/bigip.conf configuration files are synchronized (made identical) each time the process is run.
• D. Multiple files, including /config/bigip.conf and /config/bigip_base.conf, are synchronized (made identical) each time the process is run.

Answer: C

NEW QUESTION 14
A BIG-IP Administrator remotely connects to the appliance via out-of-band management using https://mybigip mycompany net. The management portal has been working all week. When the administrator attempts to login today, the connection times out. Which two aspects should the administrator verify? (Choose two)

• A. DNS is property resolving the FQDN of the device.
• B. The device is NOT redirecting them to http.
• C. The administrator has the latest version of the web browser.
• D. Packet Filters on the device are blocking port 80.
• E. The administrator has TCP connectivity to the device.

Answer: AE

NEW QUESTION 15
The incoming client IP address is 195.64.45.52 and the last five connections have been sent to members A, C, E, D and B. Given the virtual server, pool, and persistence definitions and statistics shown in the above graphic, which member will be used for the next connection?

• A. 10.10.20.1:80
• B. 10.10.20.2:80
• C. 10.10.20.3:80
• D. 10.10.20.4:80
• E. 10.10.20.5:80
• F. It cannot be determined with the information given.

Answer: C

NEW QUESTION 16
Which IP address will the client address be changed to when SNAT automap is specified within a Virtual Server configuration?

• A. The floating self-IP address on the VLAN where the packet leaves the system.
• B. The floating self-IP address on the VLAN where the packet arrives on the system.
• C. It will alternate between the floating and non floating self-IP address on the VLAN where the packet leaves the system so that port exhaustion is avoided.
• D. It will alternate between the floating and non floating self-IP address on the VLAN where the packet arrives on the system so that port exhaustion is avoided.

Answer: A

NEW QUESTION 17
......