NEW QUESTION 1
A customer asks its service provider for VPN support for IPv4 and IPv6 address families Which command enables a VRF that supports these requirements?

• A. Router(config-vrf) #route-target 004:006
• B. Router(config-vrf)#rd 004: 006
• C. Router(config)#ipvrf CUSTOMER
• D. Router(config-vrf)#vrf definition CUSTOMER

Answer: D

NEW QUESTION 2
WHICH COMMAND DO YOU ENTER ON ROUTER R6 SO THAT BGP SUPPORTS MULTIPLE PROTOCOLS?

• A. R6(config-router-af)#bgp additional-path install
• B. R6(Config-router)#no address-family ipv6 unicast
• C. R6(config-router)#no bgp default ipv4-multicast
• D. R6(confi-router)#bgp default ipv4-multicast

Answer: B

NEW QUESTION 3
You are configuring a static route. Which action must you take to avoid the possibility of recursive row

• A. Use the ip route command to specify the next-hop IP address only
• B. Specify the next hop on a directly connected interface
• C. Use the ip route command to specify both the next-hop IP address and the connected interface
• D. Use the ip route command to specify the connected interface only

Answer: C

NEW QUESTION 4
Which are new LSA types in OSPF for IPv6 (OSPFv3)? (Choose two)

• A. LSA Type 8
• B. LSA Type 9
• C. LSA Type 10
• D. LSA Type 12

Answer: AB

NEW QUESTION 5
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

• A. The lowest IP address of any physical interface
• B. The highest IP address of any physical interface
• C. The lowest IP address of any logical interface
• D. The highest IP address of any logical interface

Answer: B

NEW QUESTION 6
Refer to the exhibit.

Router DHCP is configured to lease IPv4 and IPv6 addresses to clients on ALS1 and ALS2. Clients on ALS2 receive IPv4 and IPv6 addresses Clients on ALS1 receive IPv4 addresses. Which configuration on DSW1 allows clients on ALS1 to receive IPv6 addresses'?

• A. DSW1(cunfig-if)»ipv6 dhcp relay destination 2002:404:404::404:404 GigabitEthernet1/2
• B. DSW1(configFipv6 route 2002:404:404: 404:404/128 FastEthemet1/0
• C. DSWKconfKj K)cipv6 helper address 2002:404:404:404:404
• D. DSW1 uihrp-condg^default-router 2002:A04:A01:A04:A01

Answer: D

NEW QUESTION 7
A. remaining key lifetime

• A. path MTU
• B. invalid identity packets D inbound crypto map
• C. tagged packets
• D. untagged packets

Answer: ABD

NEW QUESTION 8
Which set of actions does a network engineer perform to set the IPv6 address of a DHCP relay server at the VLAN interface level?

• A. Enter the global configuration mode, enable IPv6 DHCP relay from interface confi; mode, and define the IPv6 address of a DHCP relay server.
• B. Enter the global configuration mode and enable the IPv6 DHCP relay
• C. Enter the VLAN interface configuration mode, enable IPv6 DHCP relay, and define the IPv6 address of a DHCP relay server
• D. Enter the VLAN interface configuration mode and define the IPv6 address of a DHCP relay server.

Answer: C

NEW QUESTION 9
Which two statements about NHRP in a DMVPN environment are true (Choose two.)

• A. It routes traffic through the tunnel.
• B. It provides address resolution to route traffic.
• C. It can authenticate VPN endpoints.
• D. It requires each endpoint to have a unique network ID.
• E. It can identify PIM-SM RPs over a tunnel.

Answer: BC

NEW QUESTION 10
Which is the minimum privilege level to allow a user to execute all user-level commands but prohibits enable-level commands by default?

• A. level 0
• B. level 1
• C. level 14
• D. level 15
• E. level 16

Answer: B

NEW QUESTION 11
A route with default RIPv2 settings loses connectivity to it's next-hop neighbor. How long dows the router wait before removing the route to the next hop from its route table?

• A. 30 seconds
• B. 60 seconds
• C. 180 seconds
• D. 240 seconds

Answer: D

NEW QUESTION 12
Which two effects of symmetric routing are true? (Choose two)

• A. unicast flooding
• B. uRPF failure
• C. errdisabling of ports
• D. port security violations
• E. excessive STP reconvergence

Answer: AB

NEW QUESTION 13
Which feature can mitigate fragmentation issues within network segments that are between GRE endpoints?

• A. TCP Flow Control
• B. ICMP DF bit
• C. TCP MSS
• D. PMTU

Answer: D

NEW QUESTION 14
Refer to the exhibit.

You notice that traffic from R1 to the 192.168.10 0/24 network prefers the path through R3 instead of the least-cost path through R2.What is the most likely reason for this route selection?

• A. OSPF prefers external routes over interarea routes.
• B. OSPF prefers interarea routes over intra-area routes.
• C. OSPF prefers external routes over intra-area routes.
• D. OSPF prefers intra-area routes over interarea routes

Answer: D

NEW QUESTION 15
When OSPF is forming an adjacency, in which state does the actual exchange of the information in the link-state database occur?

• A. loading
• B. exchange
• C. INIT
• D. exstart

Answer: B

NEW QUESTION 16
Which two statements about redistributing EIGRP into OSPF are true? (Choose two)

• A. The redistributed EIGRP routes appear as type 3 LSAs in the OSPF database
• B. The redistributed EIGRP routes appear as type 5 LSAs in the OSPF database
• C. The administrative distance of the redistributed routes is 170
• D. The redistributed EIGRP routes appear as OSPF external type 1
• E. The redistributed EIGRP routes as placed into an OSPF area whose area ID matches the EIGRP autonomous system number
• F. The redistributed EIGRP routes appear as OSPF external type 2 routes in the routing table

Answer: BF

NEW QUESTION 17
How big is the smallest packet that will always be fragmented on a standard Ethernet network with default configuration?

• A. 1500 bytes
• B. 1800 bytes
• C. 2048 bytes
• D. 2100bytes

Answer: A

NEW QUESTION 18
What is supported radius server? (choose two)

• A. telnet
• B. authentication
• C. accounting
• D. authorization
• E. SSH

Answer: BD

NEW QUESTION 19
Drag and drop the statement about device security from the left on the correct features on the right.

Answer:

Explanation:

NEW QUESTION 20
Which two statements are limitations of stateful NAT64? (Choose two)

• A. It supports DNS64 only
• B. Layer 4 supports TCP only
• C. It is unable to route VRF traffic
• D. It is unable to route multicast traffic
• E. It supports FTP traffic only with an ALG

Answer: CD