NEW QUESTION 1
The command storm-control broadcast level 75 65 is configured under the switch port connected to the corporate mail server. In which three ways does this command impact the traffic? (Choose three.)

• A. SNMP traps are sent by default when broadcast traffic reaches 65% of the lower-level threshold.
• B. The switchport is disabled when unicast traffic reaches 75% of the total interface bandwidth.
• C. The switch resumes forwarding broadcasts when they are below 65% of bandwidth.
• D. Only broadcast traffic is limited by this particular storm control configuration.
• E. Multicast traffic is dropped at 65% and broadcast traffic is dropped at 75% of the total interface bandwidth.
• F. The switch drops broadcasts when they reach 75% of bandwidth.

Answer: CDF

NEW QUESTION 2
Which command configures VLAN 99 as an untagged VLAN on a trunk?

• A. switchport access vlan 99
• B. switchport trunk pruning vlan except 99
• C. switchport trunk allowed vlan 99
• D. switchport trunk native vlan 99

Answer: D

NEW QUESTION 3
A new network that consists of several switches has been connected together via trunking interfaces. If all switches currently have the default VTP domain name "null", which statement describes what happens when a domain name is configured on one of the switches?

• A. The switch with the non-default domain name restores back to "null" upon reboot.
• B. Switches with higher revision numbers does not accept the new domain name.
• C. VTP summary advertisements are sent out of all ports with the new domain name.
• D. All other switches with the default domain name become VTP clients.

Answer: C

NEW QUESTION 4
In which EtherChannel mode does a port receive and respond to PAgP messages without EtherChannel communication?

• A. on
• B. auto
• C. active
• D. desirable

Answer: B

NEW QUESTION 5
Which two types of threshold can you configure for tracking objects? (Choose two.)

• A. weight
• B. bandwidth
• C. MTU
• D. percentage
• E. administrative distance 15
• F. delay

Answer: AD

NEW QUESTION 6
In regards to Cisco Virtual Switching System which technology is needed between two switches for them to act as one network element and share control information and data traffic?

• A. trunk
• B. virtual port channel
• C. EtherChannel
• D. virtual switch link

Answer: D

NEW QUESTION 7
ADHCP configured router is connected directly to a switch that has been provisioned with DHCP snooping. IP Source Guard with the ip verify source port-security command is configured under the interfaces that connect to all DHCP clients on the switch. However, clients are not receiving an IP address via the DHCP server. Which option is the cause of this issue?

• A. The DHCP server does not support information option 82.
• B. The DHCP client interfaces have storm control configured.
• C. Static DHCP bindings are not configured on the switch.
• D. DHCP snooping must be enabled on all VLANs, even if they are not utilized for dynamic address allocation.

Answer: A

NEW QUESTION 8
Which statement about using native VLANs to carry untagged frames is true?

• A. Cisco Discovery Protocol version 2 carries native VLAN information, but version 1 does not.
• B. Cisco Discovery Protocol version 1 carries native VLAN information, but version 2 does not.
• C. Cisco Discovery Protocol version 1 and version 2 carry native VLAN information.
• D. Cisco Discovery Protocol version 3 carries native VLAN information, but versions 1 and 2 do not.

Answer: A

NEW QUESTION 9
Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.
• DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105
• DSW2 - primary device for VLAN 103 and VLAN 104
• A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on backup device has also failed.
Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to investigate and respond to the following question.


What is the priority value of the VLAN 105 HSRP group on DSW2?

• A. 50
• B. 100
• C. 150
• D. 200

Answer: B

NEW QUESTION 10
Which feature rate-limits DHCP traffic?

• A. DHCP Snooping
• B. DHCP Acknowledge
• C. DHCP Request
• D. DHCP Spoofing

Answer: A

NEW QUESTION 11
Refer to the exhibit.

Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

• A. switch1channel-group 1 mode active switch2channel-group 1 mode auto
• B. switch1channel-group 1 mode desirable switch2channel-group 1 mode passive
• C. switch1channel-group 1 mode on switch2channel-group 1 mode auto
• D. switch1channel-group 1 mode desirable switch2channel-group 1 mode auto

Answer: D

NEW QUESTION 12
An access switch has been configured with an EtherChannel port. After configuring SPAN to monitor this port, the network administrator notices that not all traffic is being replicated to the management server. What is a cause for this issue?

• A. VLAN filters are required to ensure traffic mirrors effectively.
• B. SPAN encapsulation replication must be enabled to capture EtherChannel destination traffic.
• C. The port channel can be used as a SPAN source, but not a destination.
• D. RSPAN must be used to capture EtherChannel bidirectional traffic.

Answer: C

NEW QUESTION 13
Which statement about the configuration of MST on an IOS switch is true?

• A. When MST is enable
• B. RSTP is automatically enabled and MST will use BPDU version 4, maximum of 16 instances of MST can exist
• C. When MST is enable
• D. RSTP is automatically disabled and MST will use BPDU version 2. maximum of 16 instances of MST can exist.
• E. When MST is enable
• F. RSTP is automatically enabled and MST will use BPDU version 2, maximum of 16 instances of MST can exist.
• G. When MST is enabled, RSTP is automatically disabled and MST will use BPDU version 4, maximum of 16 instances of MST can exist.

Answer: C

NEW QUESTION 14
Drag the description from the left to add on appropriate section on right

Answer:

Explanation:

NEW QUESTION 15
A network is running VTPv2. After verifying all VTP settings, the network engineer notices that the new switch is not receiving the list of VLANs from the server. Which action resolves this problem?

• A. Reload the new switch.
• B. Restart the VTP process on the new switch.
• C. Reload the VTP server.
• D. Verify connected trunk ports.

Answer: D

NEW QUESTION 16
Which will identify the master switch in stack wise?

• A. lower priority
• B. higher priority
• C. lower id
• D. higher id

Answer: B

NEW QUESTION 17
Which command disables spanning tree on multiple ports?

• A. no spanning-tree vlan <vlan_range>
• B. no spanning-tree mode pvst
• C. no spanning-tree mode mst
• D. no spanning-tree mode rapid-pvst

Answer: A

NEW QUESTION 18
Which First Hop Redundancy Protocol is an IEEE Standard?

• A. GLBP
• B. HSRP
• C. VRRP
• D. OSPF

Answer: C

NEW QUESTION 19
Refer to the exhibit.

Which configuration ensures that the Cisco Discovery Protocol packet update frequency sent from DSW1 to ALS1 is half of the default value?

• A. DSW1(config)#cdp timer 90
• B. DSW1(config-if)#cdp holdtime 60
• C. DSW1(config)#cdp timer 30
• D. DSW1(config)#cdp holdtime 90
• E. DSW1(config-if)#cdp holdtime 30
• F. DSW1(config-if)#cdp timer 60

Answer: C