NEW QUESTION 1
Which statement describes what happens when a switch enters dual active recovery mode?

• A. The switch shuts down and waits for the VSL link to be restored before sending traffic.
• B. All interfaces are shut down in the formerly active virtual switch member, but the new active virtual switch forwards traffic on all links.
• C. The switch continues to forward traffic out all links and enables spanning tree on VSL link and all other links to prevent loops.
• D. The VSS detects which system was last in active state and shuts down the other switch.

Answer: B

NEW QUESTION 2
Which SDM template disables routing and supports the maximum number of unicast MAC addresses?

• A. VLAN
• B. access
• C. default
• D. routing

Answer: A

NEW QUESTION 3
Drag and drop the characteristics from the left to the matching STP mode on the right.

Answer:

Explanation:

NEW QUESTION 4
Refer to the exhibit.

Which option is the most likely explanation of the duplicate address message logged?

• A. spanning-tree loop
• B. HSRP misconfiguration
• C. a PC with IP of 10.10.1.1
• D. a hardware problem

Answer: B

NEW QUESTION 5
Which command enables you to determine whether any interface on a device was shut down as a result of a port security violation?

• A. show errdisable detect
• B. show interface err-disabled status
• C. show port-security address
• D. show port-security

Answer: D

NEW QUESTION 6
Which information in a RADIUS access request packet is encrypted?

• A. username and password
• B. entire payload
• C. entire header
• D. password

Answer: A

NEW QUESTION 7
What is the default amount by which the hot standby priority for the router is decremented or incremented when the interface goes down or comes back up?

• A. 1
• B. 5
• C. 10
• D. 15

Answer: C

NEW QUESTION 8
Which two configurations can you apply to a port so that it tags traffic with VLAN 915? (Choose two.)

• A. interface GigabitEthernet0/0 switchport mode access switchport access vlan 915
• B. interface GigabitEthernet0/0 switchport mode trunkswitchport trunk encapsulation dot1q switchport trunk allowed vlan 915
• C. interface GigabitEthernet0/0 switchport mode access switchport voice vlan 915 switchport access vlan 915
• D. interface GigabitEthernet0/0.915 encapsulation dot1q 915
• E. interface GigabitEthernet0/0.915 switchport mode access switchport access vlan 915

Answer: BD

NEW QUESTION 9
When a Layer 2 EtherChannel is configured, which statement about interaction with the Spanning Tree Protocol is true?

• A. Spanning Tree uses only the member ports for forwarding
• B. Spanning Tree uses the port channel for forwarding.
• C. Spanning Tree uses the port channel and member ports for forwarding
• D. Spanning Tree does not use port channels in loop prevention.

Answer: B

NEW QUESTION 10
What is the maximum number of virtual MAC addresses that GLBP allows per group?

• A. 2
• B. 4
• C. 6
• D. 8

Answer: B

NEW QUESTION 11
After configuring new data VLANs 1020 through 1030 on the VTP server, a network engineer notices that none of the VTP clients are receiving the updates. What is the problem?

• A. The VTP server must be reloaded.
• B. The VTP version number must be set to version 3.
• C. After each update to the VTP server, it takes up to 4 hours propagate.
• D. VTP must be stopped and restarted on the server.
• E. Another switch in the domain has a higher revision number than the server.

Answer: B

NEW QUESTION 12
Which four LACP components are used to determine which hot-standby links become active after an interface failure within an EtherChannel bundle? (Choose four.)

• A. LACP system priority
• B. LACP port priority
• C. interface MAC address
• D. system ID
• E. port number
• F. hot-standby link identification number
• G. interface bandwidth

Answer: ABDE

NEW QUESTION 13
A server with a statically assigned IP address is attached to a switch that is provisioned for DHCP snooping. For more protection against malicious attacks, the network team is considering enabling dynamic ARP inspection alongside DHCP snooping. Which solution ensures that the server maintains network reachability in the future?

• A. Disable DHCP snooping information option.
• B. Configure a static DHCP snooping binding entry on the switch.
• C. Trust the interface that is connected to the server with the ip dhcp snooping trust command.
• D. Verify the source MAC address of all untrusted interfaces with ip dhcp snooping verify mac-address command.

Answer: B

NEW QUESTION 14
Refer to the output below.

Which two commands remove VLAN 100 from the VLANs allowed on the trunk port? (Choose two )

• A. switchport trunk allowed vlan 81-97.99.101-121
• B. switchport trunk allowed vlan 81-121 remove 98,100
• C. switchport trunk allowed vlan remove 100
• D. switchport trunk vlan remove 100
• E. no switchport trunk allowed vlan 100

Answer: AC

NEW QUESTION 15
Which two statements about SDM templates are true?

• A. They are used to allocate system resources
• B. Changing the SDM template will not disturb switch operation.
• C. You can verify the SDM template that is in use with the show sdm prefer command

Answer: AC

NEW QUESTION 16
HSRP has been configured between two Company devices. Which of the following describe reasons for deploying HSRP? (Choose three)

• A. HSRP provides redundancy and fault tolerance.
• B. HSRP allows one router to automatically assume the function of the second router if the second router fails.
• C. HSRP allows one router to automatically assume the function of the second router if the second router starts.
• D. HSRP provides redundancy and load balancing.

Answer: ABD

NEW QUESTION 17
What is the maximum number of 10 Gigabit Ethernet connections that can be utilized in an EtherChannel for the virtual switch link?

• A. 4
• B. 6
• C. 8
• D. 12

Answer: C

NEW QUESTION 18
Which security feature inspects ARP packets based on valid-to-MAC address bindings?

• A. DAI
• B. BPDU guard
• C. port security
• D. IP Source Guard

Answer: A

NEW QUESTION 19
Refer to the exhibit.

Which login credentials are required when connecting to the console port in this output?

• A. none required
• B. username cisco with password cisco
• C. no username with password linepass
• D. login authentication default

Answer: A