NEW QUESTION 1
While troubleshooting a transcoding issue, where you need 32 G.711 to G.729a sessions, you realize the DSP capacity may be undersized.
Which two can support your requirement? (Choose two.)

• A. PVDM4-128
• B. PVDM4-32
• C. PVDM4-48
• D. PVDM4-16
• E. PVDM4-64

Answer: BE

NEW QUESTION 2
To achieve 720p (HD) quality at 30 frames per second on an endpoint that is running TC software, what is the minimum configured call rate?

• A. 512 kbps
• B. 1152 kbps
• C. 768 kbps
• D. 2560 kbps

Answer: B

NEW QUESTION 3
System A at Company 1 is calling System B at Company 2. The call completes, but only audio and video are present on System A from System B. What are three possible causes? (Choose three.)

• A. System ACannot call System B because it is at a different company.
• B. There is a firewall in the path that is blocking audio and video traffic from Company 1 to Company 2.
• C. The firewall at Company 1 is blocking outgoing traffic.
• D. An access list is blocking video and audio somewhere in the video and audio path between System A and System B.
• E. System A has turned off the camera and the microphone.

Answer: BDE

NEW QUESTION 4
Refer to the exhibits.

Assume that all learned SAF routes are placed in the SAF_Pt partition. The 3XXX directory number pattern is being advertised by a remote cluster and is also being blocked by the local cluster that is shown in the exhibit. An IP phone is attached to the local cluster and is configured with ACSS that contains the following partitions: SAF_Pt and Internal_Pt in this order. When the IP phone places a Call to 3001, what will occur?

• A. The call will succeed and will be placed via the SIP_Trunk.
• B. The call will fail because it will be blocked by the CCD Blocked Learned Route configuration.
• C. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk.
• D. The call will placed in a round-robin fashion between the SAF network and SIP_Trun
• E. Every other call will fail.

Answer: A

NEW QUESTION 5
Refer to the exhibit.

Which course of action will resolve the Mobile Connect issues that are shown in the exhibit?

• A. Configure the Mobility softkey on the phone.
• B. Enable the user for Cisco Mobile Connect.
• C. Make the user an owner of the phone device in the phone device configuration page.
• D. Enable the device mobility mode on the phone since it is disabled.

Answer: C

NEW QUESTION 6
Which two behaviors are correct when Cisco Unified CM has a CallManager group that consists of two subscribers? (Choose two.)

• A. If a subscriber is rebooted, endpoint registrations switch to the other subscriber, then switch back when the rebooted subscriber is back in service.
• B. Endpoints attempt to register with both subscribers in a load-balanced method
• C. If a subscriber is rebooted, endpoints deregister until the rebooted subscriber is back in service
• D. Endpoints attempt to register with the bottom subscriber in the list
• E. Endpoints attempt to register with the top subscriber in the list

Answer: AE

NEW QUESTION 7
An engineer is configuring inter-site dialing for a Company with several branch offices. Due to overlapping extensions at some sites, the site code *3XX is used, where XX is the branch number is the prefixed code. The engineer cannot dial the number at the new branch from head office. Which configuration parameter can the engineer use to resolve this issue?

• A. gatekeeper
• B. translation pattern
• C. route pattern
• D. transformation profile

Answer: A

NEW QUESTION 8
Refer to the exhibit.

When a Call between two HQ users was being conferenced with a remote user at the BR site, the conference failed. Which configuration would be needed to solve the problem?

• A. The BR_MRG must contain the transcoder devic
• B. The BR_MRGL must be assigned to the BR phones.
• C. The HQ_MRG must contain the transcoder devic
• D. The HQ_MRGL must be assigned to the HQ phones.
• E. A transcoder should be configured at the remote site and assigned to all remote phones through the BR_MRGL.
• F. The HQ_MRG must contain the transcoder devic
• G. The HQ_MRGL must be assigned to the software conference bridge.
• H. Enable the software conference bridge to support G.711 and G.729 codecs in Cisco Unified Communications Manager service parameters.

Answer: D

NEW QUESTION 9
You observe that EMCC restriction on the cluster fails when a user with a different profile logs in to another cluster. Which action can you take to correct the problem?

• A. Enable logical partitioning.
• B. Set SIP session timers to 0.
• C. Set SIP session timers to 3800.
• D. Configure the regions in Cisco Unified Communications Manager to allow EMCC.

Answer: D

NEW QUESTION 10
Joe is based out of California, USA. He is travelling to London,U.K. for a few days. The ACME Corporation recently deployed Cisco Unified Communications Manager Device Mobility, and both the USA phone (Voice Subnet 10.1.1.0/24) and the London phone (Voice Subnet 10.2.2.0/24) are registered to the same Cisco Unified Communications Manager cluster. The publisher and two subscribers are in California, and the London site has two subscribers. When Joe connects his Cisco IP phone to the London network, the phone displays the message “Device in Home Location.” Assume that call routing, CSS, and partitions are set up in accordance with the country-specific dial plan. Which statement is true?

• A. To call a U.
• B. mobile phone, Joe must dial 9 (access code) + 011(international access code in the U.S.)+ 44 22 33 44 55 (U.
• C. dial plan)
• D. Joe is unable to call internal Cisco IP phones in the London office (assuming that CSS and partitions allow the call)
• E. Joe’s Cisco IP phone does not support roaming.
• F. In the UK, the international access code is 00. To call a U.
• G. number, Joe must dial 9 (access code) + 00+1 222 333 4567 (U.
• H. dial plan)

Answer: A

NEW QUESTION 11
Refer to Exhibit:

After reviewing the trace in the exhibit, what was the Directory number of the calling party?

• A. 2001
• B. 5010
• C. 1905
• D. 2003

Answer: A

NEW QUESTION 12
Refer to the exhibit.

While reviewing Expressway-E logs, an engineer encounters an idle countdown expireDError that occurred when a Jabber client tried to register. There is a firewall in front of the Jabber client. Which cause of this error is true?

• A. SIP inspection is enabled on the firewall
• B. SIP inspection is disabled on the firewall
• C. UDP port 5061 is not allowed through the firewall
• D. TCP port 5061 is not allowed through the firewall

Answer: A

NEW QUESTION 13
When a user tries to initiate an Ad Hoc conference call from an IP phone, this message appears: No Conference Bridge Available. Which two actions resolve this issue? (Choose two.)

• A. Make sure that the Join softkey is assigned to the phone.
• B. Make sure that a Conference Bridge resource is registered to Cisco Unified Communications Manager.
• C. Reset the phone, to re-register resources.
• D. Make sure that a Conference Bridge Resource is assigned to the MRGL on the phone that initiates the conference call.

Answer: BD

NEW QUESTION 14
Upon completion of a failover task you notice that all the CTI devices are still pointing to the backup server rather than the primary server. How should you resolve this issue?

• A. Stop the CTI Manager Service on the Secondary server so that all devices using CTI register with the primary.
• B. Stop the CTI Manager Service on the Primary server so that all devices using CTI stay registered with the primary CTI server.
• C. Restart the subscriber with the CTI Manager Service on the secondary.
• D. Do nothing and wait for the next failover assuming this will revert back to the primary CTI server.

Answer: A

NEW QUESTION 15
ACME Corporation is deploying a new voice gateway. The network administrator is trying to configure the ISDN PRI T1 cards. However the router does not accept the controller t1 0/0/0 command. The administrator sees this error message: "% Invalid input detected at ‘^’ marker." To diagnose this problem, which two commands should the administrator use? (Choose two.)

• A. Use the card type t1 command
• B. Use the show call active voice brief command
• C. Use the show inventory command
• D. Use the feature activate isdn command
• E. Use the clock source line command

Answer: BE

NEW QUESTION 16
When a Caller dials 9 plus an external seven-digit number, the caller hears a fast-busy tone after a period of silence. What is causing the silence?

• A. There is no dial route for 9XXXXXXX on Cisco Unified Communications Manager.
• B. The gateway is not dropping the leading 9, and the PSTN fails.
• C. The T302 timer is waiting to expire.
• D. The caller does not have the PSTN partition in the CSS.
• E. The caller dialed the wrong number.
• F. To dial successfully, the caller must enter a Forced Authorization Code.

Answer: C

NEW QUESTION 17
Refer to the exhibits.

Assume that all learned SAF routes are placed in the SAF_Pt partition. An IP phone CSS contains the following partitions in this order: Internal_Pt, SAF_Pt. When the IP phone places a Call to 3001, what will occur?

• A. The call will succeed and will be placed via the SAF networ
• B. SAF-learned routes always take precedence.
• C. The call will fail because it will be blocked by the route pattern.
• D. The call will be placed in a round-robin fashion between the SAF network and SIP_Trunk.
• E. The call will be placed in a round-robin fashion between the SAF network and SIP_Trun
• F. Every other call will fail.

Answer: B

NEW QUESTION 18
Refer to the exhibit.

In this CUCM dial-plan, a localized translation pattern 9.1[2-9]XX[2-9]XXXXXX is configured in the Calling Search Space named LongDistance_CSS. This Translation Pattern is used to globalize the User’s dialed digits followed by matching a/+! Route Pattern as seen in the Exhibit. Users with Devices/Lines assigned to the LongDistance_CSS are reporting their calls are not proceeding until after the inter-digit timeout of 15 seconds. For example, after dialing digits 915555678309 the user does not hear ringback until after 15 seconds. What two reasons could lead to this inter-digit timeout condition? (Choose two.)

• A. Route Pattern Call Classification set to OffNet.
• B. Route Pattern does not have “Allow Overlap Sending” checked
• C. Translation Pattern has “Provide Outside Dial Tone” checked
• D. Translation Pattern does not have “Urgent Priority” checked
• E. Route Pattern does not have “Urgent Priority” checked

Answer: DE

NEW QUESTION 19
When a user attempts to log out from Cisco Extension Mobility service by pressing the services button and selecting the Cisco Extension Mobility service, the user is not able to log out. What is causing this issue?

• A. The Cisco Extension Mobility service has not been configured on the phone.
• B. The user device profile is not subscribed to the Cisco Extension Mobility service.
• C. The CTI service is not running.
• D. The logout URL that is defineDFor the Cisco Extension Mobility service is incorrect or does not exist under the IP Phone Services configuration.

Answer: B

NEW QUESTION 20
After an IP Phone gets IP address information from DHCP, what is the next step in the initialization process?

• A. CTL and ITL files are downloaded.
• B. The phone requests its VLAN information.
• C. The DHCP offer is sent from the phone
• D. The TFTP server is contacted for configuration information.
• E. Nothing else is required, the phone is operational at this stage

Answer: D